Муфты электромонтажные от производителя Fucon

Datasheet Texas Instruments TPS61132PW — Даташит

ПроизводительTexas Instruments
СерияTPS61132
МодельTPS61132PW
Datasheet Texas Instruments TPS61132PW

Преобразователь SEPIC 3,3 В, КПД 90 % с LDO 1,5 В, 200 мА для 1-элементных литий-ионных или двухэлементных приложений 16-TSSOP от -40 до 85

Datasheets

TPS6113x Synchronous SEPIC and Flyback Converter With 1.1-A Switch and Integrated LDO datasheet
PDF, 1.2 Мб, Версия: C, Файл опубликован: 29 сен 2015
Выписка из документа

Цены

11 предложений от 11 поставщиков
IC REG DL BCK/BST/LINEAR 16TSSOP
T-electron
Россия и страны СНГ
TPS61132PW
Texas Instruments
185 ₽
AiPCBA
Весь мир
TPS61132PW
Texas Instruments
380 ₽
Acme Chip
Весь мир
TPS61132PW
Texas Instruments
по запросу
ЗУМ-СМД
Россия
TPS61132PW
Texas Instruments
по запросу
Сравнительное тестирование аккумуляторов EVE Energy и Samsung типоразмера 18650

Статус

Статус продуктаВ производстве (Рекомендуется для новых разработок)
Доступность образцов у производителяДа

Корпус / Упаковка / Маркировка

Pin16
Package TypePW
Industry STD TermTSSOP
JEDEC CodeR-PDSO-G
Package QTY90
CarrierTUBE
МаркировкаPS61132
Width (мм)4.4
Length (мм)5
Thickness (мм)1
Pitch (мм).65
Max Height (мм)1.2
Mechanical DataСкачать

Параметры

Duty Cycle(Max)100 %
Iq(Typ)0.04 мА
Рабочий диапазон температурот -40 до 85 C
Package GroupTSSOP
RatingCatalog
Regulated Outputs2
Special FeaturesEnable,Light Load Efficiency,Load Disconnect,Power Good
Switch Current Limit(Min)1.1 A
Switch Current Limit(Typ)1.3 A
Switching Frequency(Max)600 kHz
Switching Frequency(Min)400 kHz
ТипConverter
Vin(Max)5.5 В
Vin(Min)1.8 В
Vout(Max)3.3 В
Vout(Min)3.3 В

Экологический статус

RoHSСовместим

Application Notes

  • Minimizing Ringing at the Switch Node of a Boost Converter
    PDF, 201 Кб, Файл опубликован: 15 сен 2006
    The application report explains how to use proper board layout and/or a snubber to reduce high-frequency ringing at the switch node of a boost converter.
  • Optimizing Resistor Dividers at a Comparator (Rev. A)
    PDF, 120 Кб, Версия: A, Файл опубликован: 3 июн 2013
  • Basic Calculation of a Boost Converter's Power Stage (Rev. C)
    PDF, 186 Кб, Версия: C, Файл опубликован: 8 янв 2014
    This application note gives the equations to calculate the power stage of a boost converter built with an IC with integrated switch and operating in continuous conduction mode. It is not intended to give details on the functionality of a boost converter (see Reference 1) or how to compensate a converter. See the references at the end of this document if more detail is needed.
  • Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. A)
    PDF, 1.1 Мб, Версия: A, Файл опубликован: 11 май 2015
  • Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
    PDF, 387 Кб, Версия: B, Файл опубликован: 15 июн 2017
  • Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs
    PDF, 130 Кб, Файл опубликован: 19 сен 2011
  • QFN and SON PCB Attachment (Rev. B)
    PDF, 821 Кб, Версия: B, Файл опубликован: 24 авг 2018
  • IQ: What it is what it isn’t and how to use it
    PDF, 198 Кб, Файл опубликован: 17 июн 2011
  • Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
    PDF, 418 Кб, Версия: A, Файл опубликован: 11 дек 2018
    When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.

Модельный ряд

Серия: TPS61132 (2)

Классификация производителя

  • Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Converter (Integrated Switch)

На английском языке: Datasheet Texas Instruments TPS61132PW

Электронные компоненты. Бесплатная доставка по России