Datasheet Linear Technology LT1567CMS8#TRPBF — Даташит

Datasheets

Цены

Купить LT1567CMS8#TRPBF на РадиоЛоцман.Цены — от 83 до 244 ₽ 9 предложений от 9 поставщиков , Active Filter Single UNIV 2nd Order 5MHz 8-Pin MSOP T/R
AllElco Electronics Весь мир	LT1567CMS8#TRPBF Analog Devices	83 ₽	Купить
AiPCBA Весь мир	LT1567CMS8#TRPBF Linear Technology	172 ₽	Купить
IC Home Весь мир	LT1567CMS8#TRPBF Analog Devices	244 ₽	Купить
Augswan Весь мир	LT1567CMS8#TRPBF Analog Devices	по запросу	Купить

Корпус / Упаковка / Маркировка

Параметры

Экологический статус

Design Notes

• Скачать
  Design Low Noise Differential Circuits Using the LT1567 Dual Amplifier Building Block &mdash DN291
  PDF, 85 Кб, Файл опубликован: 1 авг 2002
  Выписка из документа

  Design Low Noise Differential Circuits Using the LT1567 Dual
  Amplifier Building Block
  Design Note 291
  Philip Karantzalis
  Introduction
  Many communications systems use differential, low
  level (400mV to 1V peak-to-peak), analog baseband
  signals where the baseband circuitry operates from
  a single low voltage power supply (5V to 3V). Any
  differential amplifier circuit used for baseband signal
  conditioning must have very low noise and an output
  voltage swing that includes most of the power supply
  range for maximum signal dynamic range. The LTВ®1567,
  a low noise operational amplifier (1.4nV/√Hz voltage
  noise density) and a unity-gain inverter, is an excellent
  analog building block (see Figure 1) for designing low
  noise differential circuits. The gain bandwidth of the
  LT1567 amplifier is 160MHz and its slew rate is sufficient for signal frequencies up to 5MHz. The LT1567
  operates from 2.7V to 12V total power supply. The
  output voltage swing is guaranteed to be 4.4V and
  2.6V peak-to-peak, at 1k load with a single 5V and 3V
  power supply, respectively. The LT1567 is available in
  an 8-lead MSOP surface mount package. …

Статьи

• Скачать
  Design Low Noise Differential Circuits Using the LT1567 Dual Amplifier Building Block &mdash LT Journal
  PDF, 55 Кб, Файл опубликован: 1 май 2002
  Выписка из документа

  DESIGN IDEAS Design Low Noise Differential Circuits
  Using the LT1567 Dual Amplifier
  by Philip Karantzalis
  Building Block
  Introduction
  Many communications systems use
  differential, low level (400mV – 1V
  peak-to-peak), analog baseband signals, where the baseband circuitry
  operates from with a single low voltage power supply (5V to 3V). Any
  differential amplifier circuit used for
  baseband signal conditioning must
  have very low noise, and an output
  voltage swing that includes most of
  the power supply range for maximum
  signal dynamic range. The LT1567, a
  low noise operational amplifier
  (1.4nV/в€љHz voltage noise density) and
  a unity-gain inverter, is an excellent
  analog building block (see Figure 1)
  for designing low noise differential
  circuits. The typical gain bandwidth
  of the LT1567 amplifier is 180MHz
  and op amp slew rate is sufficient for …

Модельный ряд

Классификация производителя

• Signal Conditioning > Filters > Filter Building Blocks

Варианты написания:

LT1567CMS8TRPBF, LT1567CMS8 TRPBF