Datasheet Linear Technology LTC4218IDHC-12#TRPBF — Даташит

Datasheets

Цены

Купить LTC4218IDHC-12#TRPBF на РадиоЛоцман.Цены — от 134 до 397 ₽ 16 предложений от 12 поставщиков Hot Swap Controller 1CH 26.5V N-Channel Positive Low Voltage 16Pin DFN EP T/R
AllElco Electronics Весь мир	LTC4218IDHC-12#TRPBF Analog Devices	134 ₽	Купить
ChipWorker Весь мир	LTC4218IDHC-12#TRPBF Analog Devices	142 ₽	Купить
Maybo Весь мир	LTC4218IDHC-12#TRPBF Analog Devices	по запросу	Купить
Кремний Россия и страны СНГ	LTC4218IDHC-12 TRPBF Linear Technology	по запросу	Купить

Корпус / Упаковка / Маркировка

Параметры

Экологический статус

Статьи

• Скачать
  12V/100A Hot Swap Design for Server Farms &mdash LT Journal
  PDF, 264 Кб, Файл опубликован: 27 окт 2014
  Выписка из документа

  12V/100A Hot Swap Design for Server Farms
  Dan Eddleman As data centers servicing the cloud grow in speed and capacity, backplane supplies
  are called on to deliver currents that push the performance boundaries of Hot Swap
  components. Hot Swap solutions allow boards to be inserted and removed from a live
  backplane without disturbing the power distributed to other boards. A typical Hot Swap
  solution uses a series MOSFET to manage the flow of power between the backplane and
  the board—preventing glitches and faults from disrupting power to the rest of the system.
  The challenges of designing robust Hot
  Swap solutions multiply with increasing
  current demands. With load currents at
  100A, simply determining power dissipation requirements is no longer sufficient.
  Designers must pay careful attention to
  the MOSFET safe operating area (SOA) and
  understand Kelvin current sensing techniques for multiple sense resistors. This
  article shows how to address these issues
  using the example of a 12V/100A solution
  based on the LTC4218 Hot Swap controller. resistance is low during start-up (such as
  might occur during an output short-circuit
  fault), the LTC4218 detects this condition and turns off the series MOSFET.
  During start-up, the circuit’s current
  limit threshold is reduced by pulling
  the LTC4218’s ISET pin low through R4
  until the PG signal transitions high. R4’s RSENSE RESISTOR ARRAY …

Модельный ряд

Классификация производителя

• Monitor, Control and Protection > Hot Swap Controllers > Low Voltage Hot Swap Controllers

Варианты написания:

LTC4218IDHC-12TRPBF, LTC4218IDHC-12 TRPBF, LTC4218IDHC12#TRPBF, LTC4218IDHC 12#TRPBF