Datasheet NXP PCA9532PW,112 — Даташит

PCA9532
16-bit I2C-bus LED dimmer
Rev. 4.1 — 22 August 2016 Product data sheet 1. General description
The PCA9532 is a 16-bit I2C-bus and SMBus I/O expander optimized for dimming LEDs in
256 discrete steps for Red/Green/Blue (RGB) color mixing and back light applications.
The PCA9532 contains an internal oscillator with two user programmable blink rates and
duty cycles coupled to the output PWM. The LED brightness is controlled by setting the
blink rate high enough (> 100 Hz) that the blinking cannot be seen and then using the duty
cycle to vary the amount of time the LED is on and thus the average current through the
LED.
The initial setup sequence programs the two blink rates/duty cycles for each individual
PWM. From then on, only one command from the bus master is required to turn individual
LEDs ON, OFF, BLINK RATE 1 or BLINK RATE 2. Based on the programmed frequency
and duty cycle, BLINK RATE 1 and BLINK RATE 2 will cause the LEDs to appear at a
different brightness or blink at periods up to 1.69 second. The open-drain outputs directly
drive the LEDs with maximum output sink current of 25 mA per bit and 200 mA per
package (100 mA per octal).
To blink LEDs at periods greater than 1.69 second the bus master (MCU, MPU, DSP,
chip set, etc.) must send repeated commands to turn the LED on and off as is currently
done when using normal I/O expanders like the NXP Semiconductors PCF8575 or
PCA9555. Any bits not used for controlling the LEDs can be used for General Purpose
parallel Input/Output (GPIO) expansion, which provides a simple solution when additional
I/O is needed for ACPI power switches, sensors, push-buttons, alarm monitoring, fans, …