Datasheet Arlight ARL-5213RGBC — Даташит

ARL-5213RGBC/4C
Features
• • • • • Uniformlight output
Lowpowerconsumption
I.C.Compatible
Longlife-solidstatereliaility
Common cathode Descriptions
• The Red source color devices are made with AlGaInP on GaAs substrate Light Emitting Diode
• The Green source color devices are made with InGaN on sic Light Emitting Diode
• The Blue source color devices are made with InGaA1N on sic Light Emitting Diode.
Usage Notes:
• The ultra bright LED is an electrostatic insensitive device, so static electricity and surge will dam• age the LED. It is required to wear a wrist-band when handling the LED. All device, equipment,
machinery, desk and ground must be properly grounded
When using LED, it must use a protective resistor in series with DC current about 20mA Applications
• • • • Status indicators
Commercial use
Advertising Signs
Back lighting Device Selection Guide
Chip Lens Color Material Emitted Color AlGaInP Red InGaN Green InGaN Blue Package Dimensions
• • • Notes:
Other dimensions are in millimeters, tolerance is 0.25mm except being specified.
Protruded resin under flange is 1.5mm Max LED.
Bare copper alloy is exposed at tie-bar portion after cutting. Water clear Absolute Maximum Rating Parameter (Ta=25°C) Symbol Absolute Maximum Rating Unit IFPM R :60 G: 100 B: 100 mA Forward Current IFM 20 mA Reverse Voltage VR 5 V Power Dissipation PD R :60 G: 130 B: 130 mW Operating Temperature Topr -40~+80 °C Storage Temperature Tstg -40~+100 °C Soldering Temperature Tsol Reflow Soldering : 260 °C for 10 sec. Hand …

ARL-5213RGBC/4A
Features
Applications UNIFORM LIGHT OUTPUT LOW POWER CONSUMPTION I.C. COMPATIBLE LONGLIFE -SOLID STATE RELIAILITY Common Anode Status indicators Commercial use Advertising Signs Back lighting Description Package Dimensions The Red source color devices are made with AlGaInP on
GaAs substrate Light Emitting Diode The Green source color devices are made with InGaN on
sic Light Emitting Diode The Blue source color devices are made with InGaAlN on
sic Light Emitting Diode. Usage Notes
The ultra bright LED is an electrostatic insensitive device,
so static electricity and surge will damage the LED.It is
required to wear a wrist-band when handling the LED. All
device, equipment, machinery, desk and ground must be
properly grounded
When using LED, it must use a protective resistor in series
with DC current about 20mA Notes:
1. Other dimensions are in millimeters,
tolerance is 0.25mm except being
specified.
2. Protruded resin under flange is
1.5mm Max LED.
3. Bare copper alloy is exposed at tiebar portion after cutting. Device Selection Guide
Chip Part No. ARL-5213RGBC/4A Material Emitted Color AlGaInP Red InGaN Green InGaN Blue Lens Color White diffused Electrical / Optical Characteristics at TA=25В°C
Parameter Symbol Device Min Typ. Max. Units Test Conditions Iv Red
Green
Blue 1000 …