AC-DC и DC-DC преобразователи напряжения Top Power на складе ЭЛТЕХ

Datasheet AD8672 (Analog Devices) - 3

ПроизводительAnalog Devices
ОписаниеPrecision Low Noise, Low Input Bias Current Dual Op Amp
Страниц / Страница13 / 3 — DLA LAND AND MARITIME. COLUMBUS, OHIO. 16236. V62/16603
Формат / Размер файлаPDF / 80 Кб
Язык документаанглийский

DLA LAND AND MARITIME. COLUMBUS, OHIO. 16236. V62/16603

DLA LAND AND MARITIME COLUMBUS, OHIO 16236 V62/16603

41 предложений от 19 поставщиков
Микросхема Буферный усилитель, IC OPAMP GP 10MHz 8SOIC
ChipWorker
Весь мир
AD8672ARZ-REEL7
Analog Devices
176 ₽
Lixinc Electronics
Весь мир
AD8672ARZ-REEL7
Analog Devices
от 213 ₽
AD8672ARZ-REEL7
от 600 ₽
Augswan
Весь мир
AD8672ARZ-REEL7
Analog Devices
по запросу
Датчики давления азиатских производителей

Модельный ряд для этого даташита

Текстовая версия документа

1.4 Recommended operating conditions. 2/ Supply voltage range (VS) .. 5 V and 15 V Operating free-air temperature range (TA) ... -55C to +125C 2. APPLICABLE DOCUMENTS JEDEC Solid State Technology Association JEDEC PUB 95 – Registered and Standard Outlines for Semiconductor Devices (Copies of these documents are available online at http:/www.jedec.org or from JEDEC – Solid State Technology Association, 3103 North 10th Street, Suite 240–S, Arlington, VA 22201-2107). 3. REQUIREMENTS 3.1 Marking. Parts shall be permanently and legibly marked with the manufacturer’s part number as shown in 6.3 herein and as follows: A. Manufacturer’s name, CAGE code, or logo B. Pin 1 identifier C. ESDS identification (optional) 3.2 Unit container. The unit container shall be marked with the manufacturer’s part number and with items A and C (if applicable) above. 3.3 Electrical characteristics. The maximum and recommended operating conditions and electrical performance characteristics are as specified in 1.3, 1.4, and table I herein. 3.4 Design, construction, and physical dimension. The design, construction, and physical dimensions are as specified herein. 3.5 Diagrams. 3.5.1 Case outline. The case outline shall be as shown in 1.2.2 and figure 1. 3.5.2 Terminal connections. The terminal connections shall be as shown in figure 2. 2/ Use of this product beyond the manufacturers design rules or stated parameters is done at the user’s risk. The manufacturer and/or distributor maintain no responsibility or liability for product used beyond the stated limits.
DLA LAND AND MARITIME
SIZE CODE IDENT NO. DWG NO.
COLUMBUS, OHIO A 16236 V62/16603
REV PAGE 3
ТМ Электроникс. Электронные компоненты и приборы. Скидки, кэшбэк и бесплатная доставка