Источники питания Keen Side

Datasheet LT1389 (Analog Devices) - 4

ПроизводительAnalog Devices
ОписаниеNanopower Precision Shunt Voltage Reference
Страниц / Страница12 / 4 — 5V ELECTRICAL CHARACTERISTICS The. denotes specifications which apply …
Формат / Размер файлаPDF / 219 Кб
Язык документаанглийский

5V ELECTRICAL CHARACTERISTICS The. denotes specifications which apply over the full operating

5V ELECTRICAL CHARACTERISTICS The denotes specifications which apply over the full operating

16 предложений от 12 поставщиков
Опорный чип напряжения, V-Ref Precision 5V 10mA 8Pin SOIC N T/R
AllElco Electronics
Весь мир
LT1389BCS8-5#TRPBF
Analog Devices
142 ₽
Lixinc Electronics
Весь мир
LT1389BCS8-5#TRPBF
Analog Devices
от 335 ₽
Augswan
Весь мир
LT1389BCS8-5#TRPBF
Analog Devices
по запросу
Кремний
Россия и страны СНГ
LT1389BCS8-5 TRPBF
Linear Technology
по запросу

Модельный ряд для этого даташита

Текстовая версия документа

LT1389
5V ELECTRICAL CHARACTERISTICS The

denotes specifications which apply over the full operating temperature range, otherwise specifications are at TA = 25
°
C. (Note 3) PARAMETER CONDITIONS MIN TYP MAX UNITS
Reverse Breakdown Voltage LT1389BCS8 (IR = 1.5µA) 4.99625 5.000 5.00375 V – 0.075 0.075 % LT1389BCS8 (IR = 1.5µA) ● 4.979 5.000 5.021 V – 0.42 0.42 % Reverse Breakdown Change 1.5µA ≤ IR ≤ 200µA 0.2 1.5 mV with Current (Note 4) ● 0.2 3 mV 200µA ≤ IR ≤ 2mA 0.3 4 mV ● 0.3 6 mV Minimum Operating Current ● 1 µA Temperature Coefficient IR = 1.5µA ● 12 50 ppm/°C Reverse Dynamic Impedance (Note 5) 1.5µA ≤ IR ≤ 2mA 0.75 2 Ω ● 0.75 3 Ω Low Frequency Noise (Note 6) IR = 1.5µA, 0.1Hz ≤ f ≤ 10Hz 100 µVP-P
Note 1:
Absolute Maximum Ratings are those values beyond which the life
Note 4:
Output requires 0.1µF for operating current greater than 1mA. of a device may be impaired.
Note 5:
This parameter is guaranteed by “reverse breakdown change with
Note 2:
If the part is stored outside of the specific operating temperature current” test. range, the output may shift due to hysteresis.
Note 6:
Peak-to-peak noise is measured with a single highpass filter at
Note 3:
ESD (Electrostatic Discharge) sensitive device. Use proper ESD 0.1Hz and 2-pole lowpass filter at 10Hz. handling precautions. 4
ТМ Электроникс. Электронные компоненты и приборы. Скидки, кэшбэк и бесплатная доставка