LT1102 ELECTRICAL CHARACTERISTICSNote 1: Stresses beyond those listed under Absolute Maximum Ratings Note 4: This parameter is not tested. It is guaranteed by design and by may cause permanent damage to the device. Exposure to any Absolute inference from the slew rate measurement. Maximum Rating condition for extended periods may affect device Note 5: Overdrive recovery is defined as the time delay from the removal reliability and lifetime. of an input overdrive to the output’s return from saturation to linear Note 2: This parameter is tested on a sample basis only. operation. Note 3: Current noise is calculated from the formula: 50% overdrive equals VIN = ±2V (G = 10) or VIN = ±200mV (G = 100). in = (2qIB)1/2 Note 6: This parameter is not tested. It is guaranteed by design and by where q = 1.6 • 10–19 coulomb. The noise of source resistors up to 1GΩ inference from other tests. swamps the contribution of current noise. WUTYPICAL PERFOR A CE CHARACTERISTICSSmall Signal Response, G = 10Small Signal Response, G = 100Slew Rate, G = 100(Input = 50mV Pulse)(Input = 5mV Pulse)(Input = ± 130mV Pulse) 5V/DIV 100mV/DIV 100mV/DIV 2μS/DIV 2μS/DIV 2μS/DIV FPO LT1102 • TPC01 FPO LT1102 • TPC02 FPO LT1102 • TPC03 Settling Time, G = 10Settling Time, G = 10(Input From – 10V to 10V)(Input From 10V to –10V) 5mV/DIV AT SUM NODE 5mV/DIV AT SUM NODE 1μS/DIV 1μS/DIV FPO LT1102 • TPC04 FPO LT1102 • TPC05 Settling Time, G = 100Settling Time, G = 100(Input From – 10V to 10V)(Input From 10V to –10V) 5mV/DIV AT SUM NODE 5mV/DIV AT SUM NODE 2μS/DIV 2μS/DIV FPO LT1102 • TPC06 FPO LT1102 • TPC07 1102fb 5
Купить LT1102CN8#PBF на РадиоЛоцман.Цены — от 313 до 1 727 ₽
