Клеммы, реле, разъемы Degson со склада в России

Datasheet LT1192 (Analog Devices) - 4

ПроизводительAnalog Devices
ОписаниеUltrahigh Speed Operational Amplifier
Страниц / Страница12 / 4 — ELECTRICAL CHARACTERISTICS The. denotes the specifications which apply …
Формат / Размер файлаPDF / 259 Кб
Язык документаанглийский

ELECTRICAL CHARACTERISTICS The. denotes the specifications which apply over the full operating. temperature range of 0

ELECTRICAL CHARACTERISTICS The denotes the specifications which apply over the full operating temperature range of 0

25 предложений от 15 поставщиков
Микросхема Видеоусилитель, IC OP-AMP VIDEO HISPD SNGL 8SOIC
AiPCBA
Весь мир
LT1192CS8#TRPBF
Linear Technology
143 ₽
ChipWorker
Весь мир
LT1192CS8
Linear Technology
161 ₽
Maybo
Весь мир
LT1192CS8
Analog Devices
654 ₽
LT1192CS8#PBF
Linear Technology
по запросу
Датчики давления азиатских производителей

Модельный ряд для этого даташита

Текстовая версия документа

LT1192
ELECTRICAL CHARACTERISTICS The

denotes the specifications which apply over the full operating temperature range of 0
°
C

TA

70
°
C. VS =
±
5V, Pin 5 open circuit unless otherwise noted. LT1191C SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
VOS Input Offset Voltage N8 Package ● 0.4 3 mV SO-8 Package 4 mV ∆VOS/∆T Input VOS Drift ● 2 µV/°C IOS Input Offset Current ● 0.2 1.7 µA IB Input Bias Current ● ±0.5 ±2.5 µA CMRR Common Mode Rejection Ratio VCM = – 2.5V to 3.5V ● 68 85 dB PSRR Power Supply Rejection Ratio VS = ±2.375V to ±5V ● 70 90 dB AVOL Large-Signal Voltage Gain RL = 1k, VO = ±3V ● 90 140 V/mV RL = 100Ω, VO = ±3V ● 10 30 V/mV VOUT Output Voltage Swing RL = 1k ● ±3.7 ±3.9 V IS Supply Current ● 32 38 mA Shutdown Supply Current Pin 5 at V – (Note 8) ● 1.4 2.1 mA ISHDN Shutdown Pin Current Pin 5 at V – ● 20 µA
Note 1:
Absolute Maximum Ratings are those values beyond which the
Note 6:
Settling time measurement techniques are shown in “Take the life of the device may be impaired. Guesswork Out of Settling Time Measurements,” EDN, September 19,
Note 2:
A heat sink is required to keep the junction temperature below 1985. AV = –5, RL = 1k. absolute maximum when the output is shorted.
Note 7:
NTSC (3.58MHz). For RL = 1k, Diff AV = 0.1%, Diff Ph = 0.01°.
Note 3:
Exceeding the input common mode range may cause the output Diff AV and Diff Ph can be reduced for AV < 10. to invert.
Note 8:
See Applications section for shutdown at elevated temperatures.
Note 4:
Slew rate is measured between ±1V on the output, with a ±0.3V Do not operate the shutdown above TJ > 125°C. input step.
Note 9
: AC parameters are 100% tested on the ceramic and plastic DIP
Note 5:
Full-power bandwidth is calculated from the slew rate packaged parts (J and N suffix) and are sample tested on every lot of the measurement: SO packaged parts (S suffix). FPBW = SR/2πVP.
Optional Offset Nulling Circuit
5V 3 + 7 6 LT1192 2 – 4 8 –5V 1 INPUT OFFSET VOLTAGE CAN BE ADJUSTED OVER A ±20mV RANGE WITH A 1k TO 10k POTENTIOMETER Ω Ω LT1192 • TA03 4
ТМ Электроникс. Электронные компоненты и приборы. Скидки, кэшбэк и бесплатная доставка