LT1190 ELECTRICAL CHARACTERISTICS The ● denotes the specifications which apply over the full operatingtemperature range of 0 ° C ≤ TA ≤ 70 ° C. VS = ± 5V, Pin 5 open circuit unless otherwise noted.LT1190CSYMBOLPARAMETERCONDITIONSMINTYPMAXUNITS VOS Input Offset Voltage N8 Package ● 3 11 mV SO-8 Package 18 mV ∆VOS/∆T Input VOS Drift ● 16 µV/°C IOS Input Offset Current ● 0.2 1.7 µA IB Input Bias Current ● ±0.5 ±2.5 µA CMRR Common Mode Rejection Ratio VCM = – 2.5V to 3.5V ● 58 70 dB PSRR Power Supply Rejection Ratio VS = ±2.375V to ±5V ● 58 70 dB AVOL Large-Signal Voltage Gain RL = 1k, VO = ±3V ● 9 20 V/mV RL = 100Ω, VO = ±3V ● 2 6 V/mV VOUT Output Voltage Swing RL = 1k ● ±3.7 ±3.9 V IS Supply Current ● 32 38 mA Shutdown Supply Current Pin 5 at V – (Note 8) ● 1.4 2.1 mA ISHDN Shutdown Pin Current Pin 5 at V – ● 20 µA Note 1: Absolute maximum ratings are those values beyond which the life Note 6: Settling time measurement techniques are shown in “Take the of the device may be impaired. Guesswork Out of Settling Time Measurements,” EDN, September 19, Note 2: A heat sink is required to keep the junction temperature below 1985. AV = –1, RL = 1k. absolute maximum when the output is shorted. Note 7: NTSC (3.58MHz). For RL = 1k, Diff AV = 0.1%, Diff Ph = 0.06°. Note 3: Exceeding the input common mode range may cause the output Note 8: See Applications section for shutdown at elevated temperatures. to invert. Do not operate the shutdown above TJ > 125°C. Note 4: Slew rate is measured between ± 1V on the output, with a ± 3V Note 9: AC parameters are 100% tested on the ceramic and plastic DIP input step. packaged parts (J and N suffix) and are sample tested on every lot of the Note 5: Full-power bandwidth is calculated from the slew rate SO packaged parts (S suffix). measurement: FPBW = SR/2πVP. Optional Offset Nulling Circuit 5V 3 + 7 6 LT1190 2 – 4 8 –5V 1 INPUT OFFSET VOLTAGE CAN BE ADJUSTED OVER A ±150mV RANGE WITH A 1kΩ TO 10kΩ POTENTIOMETER LT1190 • TA03 4
Купить LT1190CS8#TRPBF на РадиоЛоцман.Цены — от 101 до 515 ₽
