Datasheet SIC466, SiC467, SiC468, SiC469 (Vishay) - 5

SiC466, SiC467, SiC468, SiC469
www.vishay.com Vishay Siliconix
ELECTRICAL SPECIFICATIONS
(VIN = VCIN = 48 V, TJ = -40 °C to +125 °C, unless otherwise stated)
PARAMETER SYMBOL TEST CONDITIONS MIN. TYP. MAX. UNIT Fault Protections
ILM tied to VDD - 13 - SiC466 valley current limit ILM is not connect - 9.75 - ILM tied to AGND - 6.5 - ILM tied to VDD - 10 - SiC467 valley current limit ILM is not connect - 7.5 - ILM tied to AGND - 5 - IOCP A ILM tied to VDD - 6 - SiC468 valley current limit ILM is not connect - 4.2 - ILM tied to AGND - 3 - ILM tied to VDD - 4 - SiC469 valley current limit ILM is not connect - 3 - ILM tied to AGND - 2 - Output OVP threshold OVP - 20 - VFB with respect to 0.8 V reference % Output UVP threshold UVP - -80 - OTPR Rising temperature - 150 - Over temperature protection °C OTPHYST Hysteresis - 35 -
Power Good
VFB_RISING_VTH_OV VFB rising above 0.8 V reference - 20 - Power good output threshold % VFB_FALLING_VTH_UV VFB falling below 0.8 V reference - -10 - Power good hysteresis PGOOD_HYST 30 40 55 mV Power good on resistance RON_PGOOD - 6 15 Power good delay time tDLY_PGOOD 15 25 35 μs
EN / MODE / Threshold
EN logic high level VEN_H 1.2 1.4 1.5 V EN logic low level VEN_L 1 1.2 1.35 EN logic hysteresis VEN_HYS 150 200 400 mV EN pull down resistance REN - 6 - M Mode pull up current IMODE - 5 - μA Power save mode enabled, V Mode 1 DD, VDRV - 2 - Pre-reg on Power save mode disabled, V Mode 2 DD, VDRV - 301 - Pre-reg on RMODE k Power save mode disabled, V Mode 3 DRV Pre-reg - 499 - off, VDD Pre-reg on, provide external VDRV Power save mode enabled, V Mode 4 DRV Pre-reg off, - 1000 - VDD Pre-reg on, provide external VDRV
Note
(1) Guaranteed by design S19-0911-Rev. E, 28-Oct-2019
5
Document Number: 76044 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000