Поставки продукции Nuvoton по официальным каналам

Datasheet VSE-K96 OFDM Vector Signal Analysis Application (Rohde&Schwarz) - 3

ПроизводительRohde&Schwarz
ОписаниеVSE-K96 OFDM Vector Signal Analysis Application Specifications
Страниц / Страница8 / 3 — Version 01.00, August 2017. Definitions General. Specifications with …
Версия01.00
Формат / Размер файлаPDF / 1.3 Мб
Язык документаанглийский

Version 01.00, August 2017. Definitions General. Specifications with limits. Specifications without limits. Typical data (typ.)

Version 01.00, August 2017 Definitions General Specifications with limits Specifications without limits Typical data (typ.)

Текстовая версия документа

Version 01.00, August 2017 Definitions General
Product data applies under the following conditions: Three hours storage at ambient temperature followed by 30 minutes warm-up operation Specified environmental conditions met Recommended calibration interval adhered to All internal automatic adjustments performed, if applicable
Specifications with limits
Represent warranted product performance by means of a range of values for the specified parameter. These specifications are marked with limiting symbols such as <, ≤, >, ≥, ±, or descriptions such as maximum, limit of, minimum. Compliance is ensured by testing or is derived from the design. Test limits are narrowed by guard bands to take into account measurement uncertainties, drift and aging, if applicable.
Specifications without limits
Represent warranted product performance for the specified parameter. These specifications are not specially marked and represent values with no or negligible deviations from the given value (e.g. dimensions or resolution of a setting parameter). Compliance is ensured by design.
Typical data (typ.)
Characterizes product performance by means of representative information for the given parameter. When marked with <, > or as a range, it represents the performance met by approximately 80 % of the instruments at production time. Otherwise, it represents the mean value.
Nominal values (nom.)
Characterize product performance by means of a representative value for the given parameter (e.g. nominal impedance). In contrast to typical data, a statistical evaluation does not take place and the parameter is not tested during production.
Measured values (meas.)
Characterize expected product performance by means of measurement results gained from individual samples.
Uncertainties
Represent limits of measurement uncertainty for a given measurand. Uncertainty is defined with a coverage factor of 2 and has been calculated in line with the rules of the Guide to the Expression of Uncertainty in Measurement (GUM), taking into account environmental conditions, aging, wear and tear. Device settings and GUI parameters are indicated as follows: “parameter: value”. Typical data as well as nominal and measured values are not warranted by Rohde & Schwarz.
Rohde & Schwarz
R&S®VSE-K96 OFDM Vector Signal Analysis Application
3
ТМ Электроникс. Электронные компоненты и приборы. Скидки, кэшбэк и бесплатная доставка