Схемы - Питание

Stephen Woodward

There’s been interest recently here in the land of Design Ideas (DIs) in a family of simple interface circuits for pulse width modulation (PWM) control of generic voltage regulators (both linear and switching). Members of the family rely on ...

Jim Windgassen

The switching power supply in Figure 1 produces 3.3 V dc from an input voltage of 2.5 to 20 V dc with high efficiency. The circuit operates at an input voltage as low as 1.5 V once it starts from a minimum of 2.5 V dc, allowing the switcher to ...

Jayapal Ramalingam

My Design Idea (DI), “Flip ON Flop OFF for 48-VDC systems“ ( Ref. 1 ), was published and referenced Stephen Woodward’s earlier “Flip ON Flop OFF” ( Ref. 2 ) circuit. Other DIs published on this subject matter were for ...

Stephen Woodward

Analog topologies abound for converting current to voltage, voltage to current, voltage to frequency, and frequency to voltage, among other conversions. Figure 1 joins the flock while singing a somewhat different tune. This current, voltage, and ...

Dan Meeks

Some applications require a hot-swap controller, a circuit-breaker function, or both for dual-polarity, dc-input power-supply rails. In some hot-swap cases, the requirement is based only on inrush-current considerations. Control of the inrush ...

Anthony Smith

A simple, permanent-magnet dc motor is an essential element in a variety of products, such as toys, servo mechanisms, valve actuators, robots, and automotive electronics. In many of these applications, the motor must rotate in a given direction ...

David A. Johnson

Often you want to turn on and off power to a device with a single pushbutton switch. The circuit below performs this logic function with just a few parts and can operate from DC supplies between +3 V to about 15 V. It uses two inverters within a ...

David A. Johnson

This circuit uses a low power op Amp and a p-channel FET to form a diode function with a very low 0.05 volt voltage drop. With the selected FET, the circuit can handle up to 2 Amps of current. Higher currents are possible with a FET with a lower ...

Keith Szolusha

A common problem for power-supply designers is to create a compact, dual-polarity step-down converter. If space and cost are not concerns, the obvious solution is a pair of DC/DC converters, one for each output. But space and cost are almost always ...

Christopher Paul

Simple linear and switching voltage regulators with feedback networks of the type shown in Figure 1 are legion. Their output voltages are the reference voltage at the feedback (FB) pin multiplied by 1 + R F /R G . Recommended values of C F from 100 ...