Datasheet Texas Instruments OPA128 — Даташит

ПроизводительTexas Instruments
Datasheet Texas Instruments OPA128

Difet Electrometer-Grade Operational Amplifier


Datasheet OPA128
PDF, 138 Кб, Файл опубликован: 27 сен 2000, Страниц: 11
Difet Electrometer-Grade Operational Amplifier
Выписка из документа


25 предложений от 18 поставщиков
TEXAS INSTRUMENTS - OPA145ID - Операционный усилитель, 1 Усилитель, 5.5 МГц, 20 В/мкс, 4.5В до 36В, ± 2.25В до ± 18В,...
Весь мир
1 шт. позолоченный диp8 моно к двойному Op Amp адаптер конвертер LME49710 OPA128 OPA627 AD847 AD797 OPA111 OPA455 OPA637 AD829 AD843
134 ₽
OPA128LM никель,TO39/8
2 580 ₽
Россия и страны СНГ
Texas Instruments
по запросу
Россия и страны ТС
Texas Instruments
по запросу


Статус продуктаВ производствеВ производствеВ производствеВ производстве
Доступность образцов у производителяНетДаДаДа

Корпус / Упаковка / Маркировка

Package QTY20202020
Width (мм)
Length (мм)
Thickness (мм)
Pitch (мм)2.542.542.542.54
Max Height (мм)5.725.725.725.72
Mechanical DataСкачатьСкачатьСкачатьСкачать


Parameters / ModelsOPA128JM
Additional FeaturesN/AN/AN/AN/A
CMRR(Min), дБ80808080
CMRR(Typ), дБ118118118118
GBW(Typ), МГц1111
Input Bias Current(Max), pA0.0750.0750.0750.075
Iq per channel(Max), мА1.
Iq per channel(Typ), мА0.
Количество каналов1111
Offset Drift(Typ), uV/C5555
Рабочий диапазон температур, Cот -55 до 125от -55 до 125от -55 до 125от -55 до 125
Output Current(Typ), мА34343434
Package GroupTO-99TO-99TO-99TO-99
Package Size: mm2:W x L, PKG8TO-99: 80 mm2: 8.96 x 8.96(TO-99)8TO-99: 80 mm2: 8.96 x 8.96(TO-99)8TO-99: 80 mm2: 8.96 x 8.96(TO-99)8TO-99: 80 mm2: 8.96 x 8.96(TO-99)
Slew Rate(Typ), V/us3333
Total Supply Voltage(Max), +5V=5, +/-5V=1036363636
Total Supply Voltage(Min), +5V=5, +/-5V=1010101010
Vn at 1kHz(Typ), нВ/rtГц27272727
Vos (Offset Voltage @ 25C)(Max), мВ0.

Экологический статус


Application Notes

  • Designing Photodiode Amplifier Circuits with OPA128
    PDF, 76 Кб, Файл опубликован: 2 окт 2000
    The OPA128 ultra-low bias current operational amplifier achieves its 75fA maximum bias current without compromise. Using standard design techniques, serious performance trade-offs were required which sacrificed overall amplifier performance in order to reach femtoamp (fA = 10-15A) bias currents.
  • Diode-Connected FET Protects Op Amps
    PDF, 49 Кб, Файл опубликован: 2 окт 2000
    Providing input-overload protection for sensitive measurement circuits proves difficult when you must not degrade the circuits? performance in the process. It?s an especially tricky problem when you?re measuring a material?s dielectric properties. In such an application, an ultra-low input bias current op amp serves as a current integrator to measure a dielectric?s response to a 100V step.
  • Boost Instrument Amp CMR With Common-Mode Driven Supplies
    PDF, 175 Кб, Файл опубликован: 27 сен 2000
    Ever-increasing demands are being placed on instrumentation amplifier (IA) performance. When standard IAs can not deliver the required performance, consider this enhanced version. Dramatic performance improvements can be achieved by operating the input amplifiers of a classical three-op-amp IA from common-mode driven sub-regulated power supplies.
  • Comparison of Noise Performance of FET Transimpedence Amp/Switched Integrator
    PDF, 66 Кб, Файл опубликован: 27 сен 2000
    Low-input current FET operational amplifiers are universlly used to monitor photodetector, or more commonly photodiode currents. These photodetectors bridge the gap between a physical event, light, and electronics. There are a variey of amplifier configurations to select from and the choice is based on noise, bandwidth, offset, and linearity. A considerable amount has been written on the performan
  • Compensate Transimpedance Amplifiers Intuitively (Rev. A)
    PDF, 69 Кб, Версия: A, Файл опубликован: 30 мар 2005
    Transimpedance amplifiers are used to convert low-level photodiode currents to usable voltage signals. All too often, the amplifiers have to be empirically compensated to operate properly. The problem can be easily understood if one looks at all the elements involved.
  • Tuning in Amplifiers
    PDF, 44 Кб, Файл опубликован: 2 окт 2000
    Have you ever had the experience of designing an analog gain block with an amplifier that is specified to be unity gain stable only to find that it is oscillating out of control in your circuit? Or have you ever replaced a stable voltage feedback amplifier with a current feedback amplifier to find that the current feedback amplifier immediately oscillates when placed in the amplifier socket? Oscil
  • Single-Supply Operation of Operational Amplifiers
    PDF, 77 Кб, Файл опубликован: 2 окт 2000
    Operation of op amps from single supply voltages is useful when negative supply voltages are not available. Furthermore, certain applications using high voltage and high current op amps can derive important benefits from single supply operation.
  • Op Amp Performance Analysis
    PDF, 76 Кб, Файл опубликован: 2 окт 2000
    This bulletin reflects the analysis power gained through knowledge of an op amp circuit's feedback factor. Feedback dictates the performance of an op amp both in function and in quality. The major specifications of the amplifier descibe an open-loop device awaiting feedback direction of the end circuit's function. Just how well the amplifier performs the function reflects through the feedback inte

Модельный ряд

Серия: OPA128 (4)

Классификация производителя

  • Semiconductors> Amplifiers> Operational Amplifiers (Op Amps)> Precision Op Amps

На английском языке: Datasheet Texas Instruments OPA128

Изготовление 1-4 слойных печатных плат за $2

ADAR3000/3001 16-канальный формирователь диаграммы направленности для К/Ка диапазона частот от Analog Devices