Схемы - Измерения - 10

Tracy Allen

Fig 1’s circuit, which was developed to monitor the traffic of bumblebees into and out of the hive, differentiates “a-to-b” motion from “b-to-a” motion. When used with an optical decoder, the circuit distinguishes ...

Nick Cornford

While refurbishing an ageing audio mixer, I decided that the level meters needed special attention. Their rather horrible 100 µA edgewise movements had VU-type scales, the drive electronics being just a diode (germanium?) and a resistor. ...

Stephen Woodward

Awhile back I published a simple design idea for a thermal airspeed sensor based on a self-heated Darlington transistor pair ( Ref. 1 ). See Figure 1. Figure 1. Older design idea with self-heated Darlington thermal airflow sensor. In the circuit, ...

Jeff Witt

Capacitance sensors measure a wide variety of physical quantities, such as position, acceleration, pressure and fluid level. The capacitance changes are often much smaller than stray capacitances, especially if the sensor is remotely placed. I ...

Glen Chenier

With just one leftover op amp or comparator, you can add a battery-condition indicator to your portable circuit design. To indicate the life in an aging battery visually, the circuit in Figure 1 varies the duty cycle and flash rate of an LED when ...

Anton Mayer

You often need to measure current during circuit design and debugging. You can perform that task by breaking a path, inserting a shunt resistor, measuring its voltage, and converting the voltage to current. Unfortunately, that approach is sometimes ...

Stephen Woodward

Frequent design idea contributor, Peter Demchenko, recently published “Extending the resolution of a peripheral DAC” ( Reference 1 ). In it, Peter describes an inverting dual-supply amplifier circuit that he says is intended “ to ...